Balfour Beatty fined £285,000 after scissor lift death

September 18, 2024


Igor Malka and a second contractor, Edmund Vispulskis, had been in a scissor lift while installing cladding during the construction of a new engineering hall at the University of Birmingham on 7 January 2020.

The pair, from Lithuania, fell approximately 10 metres when their scissor lift was pushed over by a nearby crane.

This led to Malka losing his life while Vispulskis sustained injuries to his spine and broken ribs, before spending seven weeks in a neck brace. Vispulskis also required pins to be inserted in his pelvis and thigh.

Balfour Beatty had been the principal contractor while the National Buried Infrastructure Facility was being built at the university.

The crane was being used to move hydraulic equipment that had been delivered by a lorry. The equipment was set to be installed at the facility.

An HSE investigation found the incident could have been prevented had Balfour Beatty implemented better controls and put in place better communication between contractors.

There were contractors at the site that were moving the hydraulic units into place with the overhead travelling gantry crane, and another team who were installing internal cladding.

Balfour Beatty, as principal contractor on site, had a duty to ensure communication and co-operation between these contractors. There was also no lift supervisor present at the time of the incident.

The University of Birmingham was not prosecuted by HSE.

Balfour Beatty, of Churchill Place, Canary Wharf, London, pleaded guilty to safety breaches and the company was fined £285,000 and ordered to pay £21,768.88 in costs at Birmingham Crown Court on 16 September 2024.

HSE inspector Gareth Langston said: “This was a tragic incident that led to the death of a worker with another being seriously injured and still experiencing difficulties today as a result.

“Lifting operations must be properly controlled – they must be planned, with plans adhered to.”



Source link

Leave a Reply

Your email address will not be published. Required fields are marked *